Metal Fusion OUTDOOR COOKERS Instruction Manual Page 12

  • Download
  • Add to my manuals
  • Print
  • Page
    / 24
  • Table of contents
  • BOOKMARKS
  • Rated. / 5. Based on customer reviews
Page view 11
20 lb. LP
Gas Cylinder
Your model may vary from those pictured. The diagrams pictured above show examples of
cookers with adjustable and non-adjustable regulator assemblies.
HOSE CONNECTION ASSEMBLY
1. Refer to the appropriate diagram for your cooker below.
2. Wrench tighten the 3/8” female flare swivel to the brass adapter. If assembling a hose to a cast
burner, determine if your hose has a 3/8” female flare swivel end or a 1/8” male pipe thread end. If your
cooker has a 3/8” female flare end, wrench tighten it to the pre-installed half union located on the cast burner.
If it has a 1/8” male pipe thread end, tighten the hose fitting into the venturi with a torque wrench, up to a
torque of 95 to 105 lb./in. Alternatively, hand tighten securely and then, using a wrench, tighten an additional
1-1 1/2 turns.
3. The hose to burner (brass adapter) connection(s) must be tightened and leak tested. See leak test instructions
before use.
4. Go to the Use and Care Section of this manual for further instructions.
12
ADJUSTABLE REGULATOR
ASSEMBLY
* Models may vary from picture.
NON-ADJUSTABLE REGULATOR
WITH MANUAL VALVES ASSEMBLY
JET PIPE
JET PIPES
BAFFLE
0RIFICE
BRASS
ADAPTER
3/8 FEMALE
FLARE SWIVEL
ORIFICE CAP
(DO NOT REMOVE THIS FITTING)
The orifice is the drilled hole in the brass cap
which should be pointing up directly into the jet pipe.
ADJUSTABLE REGULATOR
TYPE 1 CONNECTION
TYPE 1
CONNECTION
NON-ADJUSTABLE
HIGH PRESSURE
REGULATOR
TEE
L.P. HOSE
MANUAL VALVES
L.P. HOSE
CAST BURNER
(Hose to cast burner assembly will either be made with a 3/8 Female Flare Swivel and Half
Union or a 1/8 Male Pipe Thread depending upon model.)
AIR SHUTTER
ORIFICE
HALF UNION
VENTURI TUBE
3/8 FEMALE
FLARE SWIVEL
3/8 FEMALE
FLARE
SWIVEL
AIR SHUTTER
ORIFICE
VENTURI TUBE
1/8 MALE
PIPE THREAD
ORIFICE CAP
(DO NOT REMOVE THIS FITTING)
The orifice is the drilled hole in the brass cap
which should be pointing up directly into the jet pipe.
BRASS ADAPTER
Page view 11
1 2 ... 7 8 9 10 11 12 13 14 15 16 17 ... 23 24

Comments to this Manuals

No comments