Metal Fusion OUTDOOR COOKERS Instruction Manual download pdf (Page 11)

6. Locate the three separate heat plate pieces. Lay the plates on a flat surface as shown in Figure 5.

Place the rounded inner edge of one plate against the vertical jet pipe located on the bottom

frame. The bottom of the plate should be located above the the “bent” prongs when installed (3

“bent” prongs welded to side of jet pipe.) The plate will fit around the “bent” area of the prong

using the cutouts provided on the plate. Repeat procedure with the second plate. Align the bolt

holes of the first and second plates and attach with bolt, lock washer and nut. Repeat procedure

with the third plate. Tighten all bolts/nuts. Reference Figure 6 for picture of heat plate assembly.

7. Install casting into top frame by following the instructions below -

a. Remove top nut from casting bolt. Leave bottom nut attached and tightened (if applicable).

b. Insert casting bolt through the hole drilled in flatbar that is welded to the base of the

windshroud.

c. Reinstall nut to casting bolt. Wrench tighten. Make sure casting is pointing straight up and is

sturdy.

d. See below Figure 7 for picture of casting assembly.

Bottom Frame

Top Frame

Flat Bar

Casting

Windshroud

Heat Plate

Assembled

“Bent”

Prong

Jet Pipe

Figure 5

Figure 6

Figure 7

“Bent” Prong

Cutouts

1 2 ... 6 7 8 9 10 11 12 13 14 15 16 ... 23 24

No comments

Metal Fusion OUTDOOR COOKERS Instruction Manual Page 11